| Solaris / ESX - Networking Issues |
| Vendor | Sun |
| Platform | Solaris |
| Version | 10 x86 |
| UNIX / Linux - Solaris |
| Sunday, 02 November 2008 23:10 |
|
Networking connectivity Issue / Dropping packets Ok, so I finally installed Solaris 10 32bit, but then found that the network interface keep dropping packets (??) Installing VMware tools has affected your machine being able to plumb pcn0 Due to this when you reboot your get networking errors and also the system telling you it cannot plumb pcn0 In order to resolve this you will need to rename the interface which you can do via the following command (in this example the interface i am changing is pcn0), mv /etc/hostname.pcn0 /etc/hostname.vmxnet0 ; perl -pi -e 's/pcn0/vmxnet0/g' /etc/hosts Once complete run the ifconfig commands to plumb the device (vmxnet0) and also bring the interface up. More information on configuring Solaris interfaces can be found here. |
Latest Articles
- F5 LTM VE 10.2.x - Interfaces not recognised
- Cisco ASA - Security Levels / NAT Control
- F5 LTM - OneConnect
- Django - CSRF verification failed. Request aborted.
- F5 LTM VE - Unable to attach to PCI device 02:01.00 for Interface 1.1
- F5 LTM - Connection Management
- Brocade ADX - FTP
- PKI - Chain of Trust
- Juniper SRX - Site to Site VPN using a Dynamic IP address
- F5 LTM - How do I perform software installations ?
- Juniper SRX - NAT
- Juniper SRX - How to configure a route based VPN
- Juniper SRX - Dynamic VPN
- Juniper SRX - How to configure a policy based VPN
- Brocade ADX - NAT
- Brocade ADX - CSW nested rules
- How do I upgrade a Juniper SRX Series gateway
- Cisco ASA - How do I capture ARP`s ?
- Juniper SRX - Configuring Source NAT with pool
- Running a packet capture on a Juniper SRX
Popular
- Proxy ARP – SPLAT
- Check Point Commands
- IPSO - Commands
- ASA 8.3 - How to configure NAT
- vSphere - Creating User and Group Permissions
- PEMU - Free Cisco PIX Firewall Emulator / Simulator
- Configuring Wireless Connectivity within Backtrack 4 r2
- Juniper Netscreen Commands
- Juniper Netscreen - NAT Explained
- How do I install snmpwalk / snmpget using Yum ?
- Netscreen - NSRP
- ESX Convertor - The session is not authenticated
- Troubleshooting a Netscreen Site 2 Site VPN
- ESX - ViClient Cannot connect to host
- Endpoint Connect Installation / Troubleshooting Guide
- Check Point - How to Reset SIC
- ESXi - Connecting to a named pipe
- Netscreen - Routing Basics / Virtual Routers / PBR
- Configuring Windows 2008 R2 as an NTP Server
- Check Point Logging Troubleshooting Guide


