| Joomla Site shows : Redirect Loop: Firefox has detected that the server is redirecting the request for this address in a way that will never complete |
| Vendor | Open Source Matters |
| Platform | Joomla |
| Version | 1.5.x |
| WebDev - Joomla |
| Friday, 05 February 2010 10:00 |
|
Issue When trying to access certain URLs within your Joomla site you may receive the error below. Solution In most cases this issue will be down to the SEF settings for your Joomla site. In my case I found that I had enabled SEF twice. Once as an additional component and again within "Site -> Global Configuration -> SEO Settings -> Search Engine Freindly URL`s". I found disabling SEF from the main Joomla settings within Global Configuration and clearing the sites cache "Tools -> Clean Cache" resolved the Redirect Loop issue. Please Note : This error can be caused by a number of different factors, and you may find that this solution may not work for you. |
Latest Articles
- F5 LTM VE 10.2.x - Interfaces not recognised
- Cisco ASA - Security Levels / NAT Control
- F5 LTM - OneConnect
- Django - CSRF verification failed. Request aborted.
- F5 LTM VE - Unable to attach to PCI device 02:01.00 for Interface 1.1
- F5 LTM - Connection Management
- Brocade ADX - FTP
- PKI - Chain of Trust
- Juniper SRX - Site to Site VPN using a Dynamic IP address
- F5 LTM - How do I perform software installations ?
- Juniper SRX - NAT
- Juniper SRX - How to configure a route based VPN
- Juniper SRX - Dynamic VPN
- Juniper SRX - How to configure a policy based VPN
- Brocade ADX - NAT
- Brocade ADX - CSW nested rules
- How do I upgrade a Juniper SRX Series gateway
- Cisco ASA - How do I capture ARP`s ?
- Juniper SRX - Configuring Source NAT with pool
- Running a packet capture on a Juniper SRX
Popular
- Proxy ARP – SPLAT
- Check Point Commands
- IPSO - Commands
- ASA 8.3 - How to configure NAT
- vSphere - Creating User and Group Permissions
- PEMU - Free Cisco PIX Firewall Emulator / Simulator
- Configuring Wireless Connectivity within Backtrack 4 r2
- Juniper Netscreen Commands
- Juniper Netscreen - NAT Explained
- How do I install snmpwalk / snmpget using Yum ?
- Netscreen - NSRP
- ESX Convertor - The session is not authenticated
- Troubleshooting a Netscreen Site 2 Site VPN
- ESX - ViClient Cannot connect to host
- Endpoint Connect Installation / Troubleshooting Guide
- Check Point - How to Reset SIC
- ESXi - Connecting to a named pipe
- Netscreen - Routing Basics / Virtual Routers / PBR
- Configuring Windows 2008 R2 as an NTP Server
- Check Point Logging Troubleshooting Guide


