| UNIX - IP Forwarding |
| UNIX / Linux - General UNIX |
| Wednesday, 27 August 2008 10:38 |
|
IP forwarding is the process of forwarding packets from one network to another. Below shows the necessary steps to enable/disable IP forwarding. SolarisEnable IP Forwarding ndd -set /dev/ip ip_forwarding 1 Disable IP forwarding ndd -set /dev/ip ip_forwarding 0 Check the status ndd -get /dev/ip ip_forwarding Linux KernelIf the output is 1 IP forwarding is enabled, cat /proc/sys/net/ipv4/ip_forward If the output is 0, run this command, cat 1 > /proc/sys/net/ipv4/ip_forward |
Latest Articles
- F5 LTM VE 10.2.x - Interfaces not recognised
- Cisco ASA - Security Levels / NAT Control
- F5 LTM - OneConnect
- Django - CSRF verification failed. Request aborted.
- F5 LTM VE - Unable to attach to PCI device 02:01.00 for Interface 1.1
- F5 LTM - Connection Management
- Brocade ADX - FTP
- PKI - Chain of Trust
- Juniper SRX - Site to Site VPN using a Dynamic IP address
- F5 LTM - How do I perform software installations ?
- Juniper SRX - NAT
- Juniper SRX - How to configure a route based VPN
- Juniper SRX - Dynamic VPN
- Juniper SRX - How to configure a policy based VPN
- Brocade ADX - NAT
- Brocade ADX - CSW nested rules
- How do I upgrade a Juniper SRX Series gateway
- Cisco ASA - How do I capture ARP`s ?
- Juniper SRX - Configuring Source NAT with pool
- Running a packet capture on a Juniper SRX
Popular
- Proxy ARP – SPLAT
- Check Point Commands
- IPSO - Commands
- ASA 8.3 - How to configure NAT
- vSphere - Creating User and Group Permissions
- PEMU - Free Cisco PIX Firewall Emulator / Simulator
- Configuring Wireless Connectivity within Backtrack 4 r2
- Juniper Netscreen Commands
- Juniper Netscreen - NAT Explained
- How do I install snmpwalk / snmpget using Yum ?
- Netscreen - NSRP
- ESX Convertor - The session is not authenticated
- Troubleshooting a Netscreen Site 2 Site VPN
- ESX - ViClient Cannot connect to host
- Endpoint Connect Installation / Troubleshooting Guide
- Check Point - How to Reset SIC
- ESXi - Connecting to a named pipe
- Netscreen - Routing Basics / Virtual Routers / PBR
- Check Point Logging Troubleshooting Guide
- Configuring Windows 2008 R2 as an NTP Server
